Miscellaneous Setup - Integra DTR-4.9 Instruction Manual

Advanced Setup—Continued

Miscellaneous Setup

This section explains items on the Miscellaneous menu.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2
Use the Up and Down [
buttons to select
"6. Miscellaneous," and then
press [Enter].
3 Make sure that "6-1.Vol-
umeSetup" is shown on the dis-
play, and then press [Enter].
4 Use the Up and Down [
buttons to select an item, and
use the Left and Right [
buttons to change it.
The items are explained below.
5
When you've finished, press the
[Setup] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
62
Volume Setup
■ MaxVolume
With this setting, you can limit the maximum volume.
The Maximum Volume range is Off, 79 to 30.
■ PowOn Vol
This setting determines what the volume will be each
time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.
]/[ ]
Note:
• The Power On Volume setting cannot be set higher
than the Maximum Volume setting.
■ Z2MaxVol (Zone 2 Max. Volume)
With this setting, you can limit the maximum volume for
Zone 2.
The Maximum Volume range is Off, 79 to 30.
■ Z2Pon Vol (Zone 2 Power On Volume)
This setting determines what the volume will be for Zone
2 each time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.
■ HP Level
With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
]/[ ]
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
]/[ ]
headphone level can be set from –12 dB to +12 dB.