Adjusting The Listening Modes; Using The Audio Adjust Settings - Integra DTR-4.9 Instruction Manual

Adjusting the Listening Modes

Using the Audio Adjust Settings

With the Audio Adjust functions and settings, you can
adjust the sound and listening modes as you like.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2 Use the Up and Down [ ]/[ ]
buttons to select "3. Audio
Adjust," and then press [Enter].
3
Use the Up and Down [ ]/[ ]
buttons to select an item, and
then press [Enter].
4
Use the Up and Down [ ]/[ ]
buttons to select an option, and
use the Left and Right [
buttons to change it.
The Audio Adjust menu items are
explained below.
5 When you've finished, press the
[Setup] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
The Audio Adjust settings are explained below.
Multiplex/Mono Settings
Mux (Multiplex)
■ Input (Mux)
This setting determines which channel of a stereo multi-
plex source is output. Use it to select audio channels or
languages with multiplex sources, multilingual TV
broadcasts, and so on.
Main: The main channel is output (default).
Sub: The sub channel is output.
M/S: Both the main and sub channels are output.
Mono
■ Input (Mono)
This setting determines which channel is output when
the Mono listening mode is used with a stereo source.
L+R: Both the left and right channels are output
(default).
L: Only the left channel is output.
R: Only the right channel is output.
PLII/Neo:6 Settings
PLII Music (2 ch Input)
These settings apply to only 2-channel stereo sources.
These settings apply to Dolby Pro Logic II.
■ Panorama
With this setting, you can broaden the width of the front
]/[ ]
stereo image when using the Dolby Pro Logic II Music
listening mode.
On: Panorama function on.
Off: Panorama function off (default).
■ Dimension
With this setting, you can move the sound field forward
or backward when using the Dolby Pro Logic II Music
listening mode. It can be adjusted from –3 to +3. The
default value is 0. Higher settings move the sound field
backward. Lower settings move it forward.
If the stereo image feels too wide, or there's too much
surround sound, move the sound field forward to
improve the balance. Conversely, if the stereo image
feels like it's in mono, or there's not enough surround
sound, move it backward.
57