Connecting Integra/Onkyo Components; Connecting A Recording Component - Integra DTR-70.3 Instruction Manual

Connecting Integra/Onkyo
1
Make sure that each Integra/Onkyo component is
connected with an analog audio cable (connection
in the hookup examples)
2
Make the connection (see the illustration).
3
If you're using an RI Dock or cassette tape deck,
change the Input Display
With (Remote Interactive), you can use the following
special functions:
■
Auto Power On
When you start playback on a component connected via
while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that
component as the input source.
■
System Off
When you turn off the AV receiver, the components
turn off automatically.
■
Remote Control
You can use the AV receiver's remote controller to
control your other
components, pointing the remote controller at the AV
receiver's remote control sensor instead of the
component. You must enter the appropriate remote
control code first

Connecting a Recording Component

See "Recording" for details on recording
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.
En
20
Components
(➔ page 18).
(➔ page 42).
-capable Integra/Onkyo
(➔ page 80).
(➔ page 44).
L R
AUDIO
IN
e.g., cassette tape deck
Note
• Use only cables for
with Integra/Onkyo components.
• Some components have two
one to the AV receiver. The other jack is for connecting
additional -capable components.
• Connect only Integra/Onkyo components to
Connecting other manufacturer's components may cause a
malfunction.
• Some components may not support all
the manuals supplied with your Integra/Onkyo components.
• While Zone 2/3/4 is on, the System Off, Auto Power On and
Direct Change
Note
• The AV receiver must be turned on for recording. Recording is
not possible while it's in standby mode.
• If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR's audio and video outputs directly to the
recording VCR's audio and video inputs. See the manuals
supplied with your TV and VCR for details.
• Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
• The surround sound and DSP listening modes cannot be
recorded.
• Copy-protected Blu-ray Discs and DVDs cannot be recorded.
VIDEO
• Sources connected to a digital input cannot be recorded. Only
IN
analog inputs can be recorded.
• DTS signals will be recorded as noise, so don't attempt analog
recording of DTS CDs or LDs.
R
ANALOG
AUDIO OUT
R
ANALOG
AUDIO OUT
RI Dock
connections. cables are supplied
jacks. You can connect either
jacks.
functions. Refer to
functions do not work.
L
L