Integra DTR-4.9 Instruction Manual page 82

Troubleshooting—Continued
Can't control other components
• Make sure you've selected the correct remote control-
ler mode.
• If you've connected an
recorder, CD recorder, or RI Dock to the TAPE
IN/OUT jacks, or an RI Dock to the GAME/TV IN
jacks, for the remote controller to work properly, you
must set the Input Display to MD, CDR, or DOCK,
respectively (see page 41).
• The entered remote control code may not be correct. If
more than one code is listed, try each one.
• With some AV components, certain buttons may not
work as expected, and some may not work at all.
• To control an Integra/Onkyo component that's con-
nected via , point the remote controller at the AV
receiver. Be sure to enter the appropriate remote con-
trol code first (page 72).
• To control an Integra/Onkyo component that's not
connected via
nent, point the remote controller at that component. Be
sure to enter the appropriate remote control code first
(page 71).
Recording
Can't record
• On your recorder, make sure the correct input is
selected.
• To prevent signal loops and damage to the AV
receiver, input signals are not fed through to outputs
with the same name (e.g., TAPE IN to TAPE OUT or
VCR/DVR IN to VCR/DVR OUT).
Others
The sound changes when I connect my head-
phones
• When a pair of headphones is connected, the listening
mode is set to Stereo, unless it's already set to Stereo,
Mono, or Direct, in which case it stays the same.
How do I change the language of a multiplex
source
• On the "Audio Adjust" menu, change the "Input
(Mux)" setting to Main or Sub (page 57).
The functions don't work
• To use , you must make an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected digi-
tally (page 33).
• While Zone 2 is selected, the
work.
82
-capable Onkyo MD
, or another manufacturer's compo-
connection and an
functions don't
The following settings can be made for the
S-Video and composite video inputs
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the
input source that you want to set, press the [Setup]
button.
2. Use the Left and Right [
the setting.
3. Press the [Setup] button when you've finished.
• Video Attenuation
This setting can be made for the DVD, VCR/DVR,
CBL/SAT, or GAME/TV input.
If you have a games console connected to the
S-Video or composite video input, and the picture
isn't very clear, you can attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal pro-
cessing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely event
that this happens, unplug the power cord from the wall out-
let, wait at least 5 seconds, and then plug it back in again.
Integra/Onkyo is not responsible for damages (such as
CD rental fees) due to unsuccessful recordings caused
by this unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
]/[ ] buttons to change