Integra DTR-4.9 Instruction Manual page 37

First Time Setup—Continued
3
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press the
[Enter] button.
4
Use the Up and Down [
buttons to select "Sp Distance,"
and then press [Enter].
5
While "Unit" is displayed, use the
Left and Right [
select "feet" or "meters".
feet: Distances can be set in feet.
Range: 1 to 30 feet in 0.5-foot
steps.
meters: Distances can be set in
meters. Range: 0.3 to 9
meters in 0.15-meter steps.
6
Use the Down [
select "Left" and use the Left and
Right [
the distance for the front speak-
ers, then press the Down [
button to select the next speaker.
7 Repeat step 6 for all speakers.
Note:
Speakers that you set to No or None in
the Speaker Configuration (page 35)
cannot be selected.
8
Press the [Setup] button.
Setup closes.
Notes:
• The Center and Subwoofer distances can be set up to
5 ft. (1.5 m) more or less than the Left distance. For
example, if the Left distance is set to 20 ft. (6 m), the
Center and Subwoofer distances can be set between 15
and 25 ft. (4.5 and 7.5 m).
• The speaker distance cannot be adjusted while a pair
of headphones is connected or the multichannel DVD
input is being used.
]/[ ]
]/[ ]
]/[ ] buttons to
] button to
]/[ ] buttons to specify
]
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Speaker Levels
You can set the volume level of each speaker so that all
speakers can be heard equally at the listening position.
1 Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press the
[Enter] button.
3
Use the Up and Down [
buttons to select "Level Cal," and
then press [Enter].
A pink noise test tone is output by the
front left speaker.
4 Turn up the volume so that you
can hear the test tone suffi-
ciently.
As each speaker outputs the test tone,
its name appears on the display.
5
Use the Left and Right [
buttons to adjust the speaker
level, and use the Down [
ton to select the next speaker.
The levels can be adjusted from –12 to
+12 dB in 1 dB steps (–15 to +12 dB
for the subwoofer).
6 Repeat step 5 so that the level of
the test tone coming from each
speaker is the same.
Speakers that you set to No or None in
the Speaker Configuration (page 35) do
not output the test tone.
]/[ ]
]/[ ]
]/[ ]
] but-
37