Replacing The Headlight Bulb - Yamaha AEROX NS50 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing the headlight bulb

If the headlight bulb burns out, replace
it as follows.
NOTICE
Take care not to damage the follow-
ing parts:
●
Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
6
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
● Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
EAUS1402
ECA10650
1. Do not touch the glass part of the bulb.
NOTICE
It is advisable to have a Yamaha
dealer perform this job.
1. Place the scooter on the center-
stand.
2. Remove cowling A. (See page
6-6.)
3. Disconnect the headlight coupler.
4. Remove the headlight bulb cover.
ZAUM0935
1. Headlight bulb cover
5. Unhook the headlight bulb holder,
ECA10670
ZAUM0936
1. Headlight bulb holder
6. Place a new headlight bulb into po-
7. Install the headlight bulb cover.
6-22
and then remove the burnt-out
bulb.
sition, and then secure it with the
bulb holder.
1
1