Replacing The Fuse; Replacing The Headlight Bulb - Yamaha C3 2008 Owner's Manual

Headlight bulb, replacing<IXE>

Replacing the fuse

1
ZAUM00**
1. Fuse
The fuse holder is located beside the
battery. Remove panel C to access the
fuse. (See page 6-7.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not use
a fuse of a higher amperage rat-
ing than recommended to avoid
causing extensive damage to the
electrical system and possibly a
fire.
[EWA15131]
PERIODIC MAINTENANCE AND ADJUSTMENT
EAUT2023 NOTICE: After removing and in-
stalling the main fuse, be sure to
turn the main switch from "ON"
to "OFF" three times in 3 seconds
intervals to initialize the idle
speed control system.
Specified fuse:
15 A
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows again,
have a Yamaha dealer check the
electrical system.

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb burns
out, replace it as follows.
[ECAT1062]
NOTICE
Do not touch the glass part of the
headlight bulb to keep it free from oil,
otherwise the transparency of the
glass, the luminosity of the bulb, and
the bulb life will be adversely affected.
Thoroughly clean off any dirt and fin-
gerprints on the headlight bulb us-
ing a cloth moistened with alcohol
or thinner.
6-57 6-22
EAU1722A
EAU23782
1
ECA10660
2
3
4
5
6
7
8
9