Replacing A Headlight Bulb - Yamaha Xenter 125 2011 Owner's Manual

Specifi ed fuses:
Main fuse:
20 A
Ignition fuse:
7.5 A
Signaling system fuse:
15 A
Headlight fuse:
15 A
Backup fuse:
7.5 A
TIP
After removing and installing the main
fuse, be sure to turn the main switch
from "ON" to "OFF" three times in
three-second intervals to initialize the
idle speed control system.
3. Turn the key to "ON" and turn on
the electrical circuit in question to
check if the device operates.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
PERIODIC MAINTENANCE AND ADJUSTMENT

Replacing a headlight bulb

This model is equipped with a halo-
gen bulb headlight. If a headlight bulb
burns out, replace it as follows.
NOTICE
Take care not to damage the follow-
ing parts:
●
Headlight bulb
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency
of the glass, the luminosity of the
bulb, and the bulb life will be ad-
versely affected. Thoroughly clean
off any dirt and fi ngerprints on the
headlight bulb using a cloth moist-
ened with alcohol or thinner.
●
Headlight lens
• D o n o t a f f i x a n y t y p e o f
tinted film or stickers to the
headlight lens.
• Do not use a headlight bulb
of a wattage higher than
specifi ed.
6-28
EAUT3660
1. Remove cowling A together with
the headlight unit. (See page
6-7.)
2. Remove the bulb cover, and then
disconnect the headlight coupler.
ECA10650
1. Headlight bulb cover
2
1. Headlight coupler
2. Headlight bulb holder
3. Headlight bulb
EAU1722A
1
2
1
3
4
5
6
1
7
8
3
9