Replacing The Fuse; Replacing The Headlight Bulb - Yamaha Neo's 4 2018 Owner's Manual

Periodic maintenance and adjustment

Replacing the fuse

1. Main fuse
6
The fuse holder is located beside the
battery. Remove panel A to access the
fuse. (See page 6-6.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "
electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
After removing and installing
the main fuse, be sure to turn
EAUM3271
the
to "
intervals to initialize the idle
speed control system.
Specified fuse:
15.0 A
3. Turn the key to "
the electrical circuits to check if
the devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.
" and turn off all
NOTICE:
[EWA15132]
main switch from "
" three times in 3 seconds
[ECAM1130]
" and turn on
6-25

Replacing the headlight bulb

"
If the headlight bulb burns out, replace
it as follows.
NOTICE
Take care not to damage the follow-
ing parts:
 Headlight bulb
Do not touch the glass part of
the headlight bulb to keep it free
from oil, otherwise the transpar-
ency of the glass, the luminosity
of the bulb, and the bulb life will
be adversely affected. Thor-
oughly clean off any dirt and fin-
gerprints on the headlight bulb
using a cloth moistened with al-
cohol or thinner.
 Headlight lens
Do not affix any type of tinted
film or stickers to the headlight
lens.
Do not use a headlight bulb of a
wattage higher than specified.
EAUS1403
ECA10651