Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha XCITY VP250 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the cowling.
6
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
1. Place the vehicle on the center-
stand.
2. Remove panel B. (See page 6-7.)
3. Remove the tail/brake light unit by
removing the screws.
ZAUM0679
1. Screw
4. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
6-28
EAUM2191
ZAUM0680
1. Tail/brake light bulb socket
2. Turn signal light bulb socket
5. Remove the burnt out bulb by
1
pushing it in and turning it counter-
clockwise.
6. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
7. Install the socket (together with the
bulb) by turning it clockwise.
8. Install the
tail/brake light unit.
9. Install the panel.
2
1
screws and the