Handlebar Switches - Yamaha XCITY VP250 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
TIP
● The oil change indicator will come
on at the initial 1000 km (600 mi)
and every 3000 km (1800 mi)
thereafter.
●
If the engine oil is changed before
the oil change indicator comes on
(i.e. before the periodic oil change
3
interval has been reached), the in-
dicator must be reset after the oil
change for the next periodic oil
change to be indicated at the cor-
rect time. After resetting, the indi-
cator will come on for two seconds.
If the indicator does not come on,
repeat the procedure.

Handlebar switches

Left
1. Dimmer " / " / Pass "
2. Turn signal switch " / "
3. Horn switch " "
Right
1
ZAUM0642
1. Start switch " "
3-6
EAU1234A
Dimmer switch "
Set this switch to "
beam and to "
With the headlight on low beam, press
this switch downwards to flash the
headlight.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
leased, the switch returns to the center
" switch
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Start switch "
With the sidestand up, push this switch
while applying the front or rear brake to
crank the engine with the starter. See
page 5-1 for starting instructions prior
to starting the engine.
EAUS1020
/ "
" for the high
" for the low beam.
EAU12460
/ "
". To signal a left-hand
". When re-
EAU12500
"
EAU12721
"