Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha VERSITY 300 VP300 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the cowling.
6
Replacing the tail/brake light
bulb or a rear turn signal light
bulb
1
ZAUM0586
1. Turn signal light bulb socket
2. Tail/brake light bulb socket
1. Place the scooter on the center-
stand.
2. Remove panel E. (See page 6-8.)
3. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
4. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6-29
EAUT1270 6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the panel.
2