Replacing A Front Turn Signal Light Bulb; Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha XCITY VP250 Owner's Manual

Replacing a front turn signal
light bulb
NOTICE
It is advisable to have a Yamaha
dealer perform this job.
1. Place the scooter on the center-
stand.
2. Remove cowling A. (See page
6-6.)
3. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
ZAUM0465
1. Turn signal light bulb socket
4. Remove the burnt out bulb by
pushing it in and turning it counter-
clockwise.
PERIODIC MAINTENANCE AND ADJUSTMENT
EAUT1261 5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
ECA10670
6. Install the socket (together with the
bulb) by turning it clockwise.
7. Install the cowling.
1
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
1. Place the vehicle on the center-
2. Remove panel B. (See page 6-6.)
3. Remove the tail/brake light unit by
ZAUM0679
1. Screw
4. Remove the socket (together with
6-26
stand.
removing the screws.
the bulb) by turning it counter-
clockwise.
EAUM2191
1
6