Replacing A Tail/Brake Ligh Bulb Or A Rear Turn Signal Light Bulb; Replacing A Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha Ego Solariz Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
5. Install the socket (together with
the bulb) by turning it clockwise.
6. Install the panel.
_
Replacing a tail/brake light
bulb or a rear turn signal light
bulb
If a tail/brake light bulb or a rear turn
signal light bulb burns out, it as follows.
Tail/brake light bulb
1. Open the seat. (See page 4-9.)
2. Remove the panel C (see page7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
1. Tail/brake light bulb
4. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
7-30
EAUU0881
5. Insert a new bulb into the socket
by pushing it in and turn it clock-
wise until it stops.
NOTICE
<CAU>
If a taillight bulb of different wattage
than recommended is used, it may
cause the battery to discharge or af-
fect the taillight lighting.
<ELB>
6. Install the bulb socket (together
with the bulb) by turning it clock-
wise.
7. Install the panel and close the
seat.
1. Open the seat. (See page 4-9.)
2. Remove panel C. (See page 7-8)
3. Remove the bulb socket (together
with the bulb) by turning it coun-
terclockwise and pulling the tail-
light bulb socket up at an angle.
ECAU0090