Replacing A Front Turn Signal Light; Replacing The Tail/Brake Light Bulb Or A Rear Turn Signal Light Bulb - Yamaha XMAX 250 YP250R Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
any dirt and fingerprints on the
headlight bulb using a cloth mois-
tened with alcohol or thinner.
5. Install the bulb cover, and then
connect the coupler.
6. Install the cowling.
7. Have a Yamaha dealer adjust the
headlight beam if necessary.
Replacing a front turn signal
light bulb
CAUTION
It is advisable to have a Yamaha
6
dealer perform this job.
1. Place the scooter on the centers-
tand.
2. Remove cowling A. (See page
6-5.)
3. Remove the socket (together
with the bulb) by turning it coun-
terclockwise.
EAUT1260
4. Remove the defective bulb by
pushing it in and turning it coun-
ECA10670
terclockwise.
5. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
6. Install the socket (together with
the bulb) by turning it clockwise.
7. Install the cowling.
6-21
Replacing the tail/brake light
bulb or a rear turn signal
light bulb
Tail/brake light bulb
1. Remove the tail/brake light bulb
lens by removing the screws.
2. Remove the defective bulb by
pushing it in and turning it coun-
terclockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screws.
EAUS1250