Troubleshooting - Toyota RSE Owner's Manual

TROUBLESHOOTING

Problem
IR Sensor Inoperative (DVD Player
Won't Accept Commands From
Remote Control)
Disc Will Not Play or Wrong
Region is Displayed
Play Starts, Then Stops
Immediately
No Sound or Distorted Sound
OSD Displays "Incorrect Disc
Format"
Solution
• Verify that the batteries in the remote are fresh.
• Verify that the remote sensor eye is not obstructed.
• Verify that monitor select M1 or monitor select M2 has been selected correctly on the
Remote Control.
• (When monitor Select M1 is pressed on the Remote Control, the remote will only operate
the passenger side monitor.)
• (When monitor Select M2 is pressed on the Remote Control, the remote will only operate
the driver side monitor.)
• Check the type of disc you put into disc slot. This DVD system only plays digital video discs,
audio CDs and MP3s.
• Both the unit and the disc are coded by region. If the regional codes don't match, the disc
can't be played. This DVD player is set to Region 1.
• The disc is dirty. Clean it.
• Condensation has formed. Allow player to dry out.
• Disc is damaged; try another disc.
• If you are using the IR headphones, make sure you turn on the IRT power with the IRT ON/
OFF button on the Remote Control. Make sure that the headphone batteries are fresh.
• If you are using the vehicle radio, make sure that there is no plug in the vehicle's AUX jack
and that the radio is in the AUX mode.
• Disc loaded backwards, turn disc around so that the disc label is facing towards the viewer.
- 30 -