Fold Flat Feature; To Operate The Headphones - Toyota RSE Owner's Manual

Fold Flat Feature

1. To use the headphones, place one ear piece in each hand,
rotate the ear pieces 90 degrees to the fully open position.
2. For storage, rotate both of the ear pieces 90 degrees to the
fold fl at position.
Figure 4. Fold Flat Feature

To Operate the Headphones

Headphones are intended for use by rear seat passengers only
and will not operate in the front seats. When sitting in front of
the passenger side monitor, move the channel select switch to
the "1" position. When sitting in front of the driver side monitor,
move the channel select switch to the "2" position.
1. Press the Power button on the right hand earpiece to turn
the headphones ON. The power indicator will illuminate red.
2. Adjust the volume level with the volume control on the
right-hand ear piece to its lowest setting before putting the
headphones on your head.
3. Press the Power button again to turn the headphones OFF.
Note: The IR transmitter must be in the ON mode. Turn
the IR transmitter ON using the Remote Control or
the touch screen. See "Remote Control Functional
Description, Item 18" on page 8 or refer to the "IRT
(Infrared Transmitter)" section on page 28.
- 11 -