Advertisement
Model: F-Series
ARRAY ASSEMBLY
(DUAL / TRIPLE DISPLAY;
FMA-220/-320 ONLY)
1. Verify that you have the following parts:
Item
Description
10
ARRAY
20
SCREW, Button Head Cap, 5/16"-18 x 4"
(Used for Pivot / Swing Arm)
30
SCREW, Button Head Cap, 5/16"-18 x 5"
(Used with Height Adjustable Arm)
40
WASHER, 5/16", UHMW (plastic)
50
WASHER, 5/16", Stainless Steel
60
PIN
70
SPACER, UHMW (plastic)
80
NUT, Nylok, 5/16"-18
90
SCREW, Button Head Cap,1/4"-20 x 1/2"
100
NUT, Square, Machine Screw, 1/4"-20
2. Install pin (60) and spacer (70) into upper mount arm
bore (See Figure 14).
70
60
80
Figure 14: Assemble Array
3. Install array (10) onto pin (60) (See Figure 14).
10
Qty
1
1
1
1
2
1
1
1
2
2
20 or 30
(20 shown; 30 similar)
50
40
50
10
4. Insert and hold nut (80) into lower mount arm bore
(See Figure 14).
5. Insert screw (20 or 30, as applicable) through washer
(50), washer (40), washer (50), array (10), array/
mount arm assembly, and into nut (80) (See Figure
14). Tighten screw as required using 3/16" hex key.
6. Slide the Centris head (dual knob assembly) onto the
array (10) (See Figure 15). Ensure both the top and
the bottoms of the Centris head are engaged into the
corresponding slots in the array (10).
NOTE: Dual display shown; triple display similar.
Figure 15: Install Display
7. Position the displays as desired and tighten the
Centris head knob closest to the array (10). See
"ADJUSTMENT" for additional information.
8. Using 5/32" hex key, install screw (90) and nut (100)
on each end of the array (10) to prevent displays from
accidently sliding off (See Figure 16).
NOTE: Left side shown; right side similar
Figure 16: Install End Locks
9. Proceed to "CABLE MANAGEMENT."
Installation Instructions
10
Centris Head
90
100
Advertisement
