Advertisement
Model: F-Series
ADJUSTMENT
ARM
PIVOT / SWING
CAUTION: If washer (80) has been used to assemble
FCY-210/-220 arms, then forced movement of arms
without loosening screw (30) will damage arm and/or Y-
connector (See Figure 17)(See Figure 19).
1. Using 3/16" hex key, slightly loosen or tighten the
adjustment screw(s) as necessary (See Figure 23).
Adjustment Screws
Figure 23: Pivot / Swing Arm Adjustment
HEIGHT ADJUSTABLE (IF APPLICABLE)
1. Using 5/32" hex key, slightly loosen or tighten the
adjustment screw as necessary (See Figure 24).
•
If display settles on its own, then rotate
adjustment screw counterclockwise (towards the
"+" symbol).
•
If display rises on its own, then rotate adjustment
screw clockwise (towards the "-" symbol).
NOTE: It may be necessary to raise or lower the height
adjustable arm to expose the adjustment screw.
Adjustment Screw
Figure 24: Height Adjustable Arm Adjustment
14
CENTRIS HEAD
SINGLE DISPLAY AND FCY-210/-220
1. If previously attached, disconnect cables from display,
then remove display.
2. Using Phillips screwdriver, slightly loosen or tighten
the adjustment screw as necessary (See Figure 25).
Adjustment Screw
Phillips Screwdriver
Figure 25: Single Display Adjustment
3. Install mount and then display cables. See "DISPLAY
INSTALLATION."
DUAL / TRIPLE DISPLAY (FMA-220/-320 ONLY)
1. LATERAL POSITION ON ARRAY:
•
Using your fingers, slightly loosen adjustment
knob "A" (See Figure 26).
•
Slide display to desired position.
•
Using your fingers, tighten adjustment knob "A".
Figure 26: Dual / Triple Display Adjustment
2. PITCH / YAW / ROLL:
•
Using your fingers, slightly loosen adjustment
knob "B" (See Figure 26).
•
Adjust display as desired.
•
Using your fingers, tighten adjustment knob "B".
Installation Instructions
A
B
Advertisement
