CHIEF Flat Panel Display Accessory Arm FSA-1003 Installation Instructions

FLAT PANEL DISPLAY ACCESSORY ARM
If you are missing any of the following components, please contact Customer Service at 1-800/582-6480
(1) Flat Panel Arm
(1) Cable Management Cover
(1) Pivot Pin
(1) Small Plastic Washer
(1) Large Plastic Washer
BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY
WARNING!
1. Using a 3/16" hex key, remove the button head cap screw securing the monitor interface to the arm or
other modular flat panel arm component (i.e. wall plate, desk clamp, etc.).
2. Install the components at each pivot in the order shown in Figure 2.
3. Using the 3/16" hex key, tighten the button head cap screws until the desired amount of pivoting
friction is achieved.
8804-000032 Rev. C
CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: chief@chiefmfg.com
INSTALLATION INSTRUCTIONS
FSA-1003 and KSA-1003
Prior to assembly, unpack carton completely and verify contents.
When using an OFB and adding additional arms to an existing
mount, the total number of arms on the mount cannot exceed two
arms.
Figure 1
(1) Button Head Cap Screw, 4.0" Long
(2) Flat Head Screw
(1) Lock Nut
(2) Steel Washer
Figure 2
04/20/05