Array Assembly (Dual / Triple Display; All Except Kcy-210/-220) - CHIEF KWP-110 Installation Instructions Manual

Model: K-Series
10
Centris
Bracket
Figure 14: Dual / Triple Display - Recessed Mount
CAUTION: Using screws of improper size may
damage your display! Proper screws will easily and
completely thread into display mounting holes.
7. Using Phillips screwdriver, install four selected
screws through the mounting holes in Centris bracket,
through the spacers, into the display (See Figure 14).
Tighten all four screws. Do not overtighten!
8. Proceed to "ARRAY ASSEMBLY."
ARRAY ASSEMBLY
(DUAL / TRIPLE DISPLAY;
ALL EXCEPT KCY-210/-220)
1. Verify that you have the following parts:
Item Description
10 ARRAY
20 SCREW, Button Head Cap, 5/16"-18 x 4"
(Used for Pivot / Swing Arm)
30 SCREW, Button Head Cap, 5/16"-18 x 5"
(Used with Height Adjustable Arm)
40 WASHER, 5/16", UHMW (plastic)
50 WASHER, 5/16", Stainless Steel
60 PIN
(ALL EXCEPT KSA-1015/-1016)
70 PIN
(KSA-1015/-1016 ONLY)
80 SPACER, UHMW (plastic)
90 SPACER, UHMW (plastic)
(KSA-1015/-1016 ONLY)
100 NUT, Nylock, 5/16"-18
110 SCREW, Button Head Cap,1/4"-20 x 1/2"
120 NUT, Square, Machine Screw, 1/4"-20
2. Install pin and spacer(s) into upper mount arm bore
(See Figure 15):
• All Except KSA-1015/-1016:
Insert pin (60) and spacer (80).
10
20 or 30
(4 places)
40 or 50
(4 places)
(60 shown; 70 similar)
3. Install array (10) onto pin (60 or 70, as applicable)
4. Insert and hold nut (100) into lower mount arm bore
5. Insert screw (20 or 30, as applicable) through washer
6. Slide the Centris head (dual knob assembly) onto the
Qty
1
1
1
1
2
1
1
1
1
1
2
2
7. Position the displays as desired and tighten the
• KSA-1015/-1016 ONLY:
Insert large spacer (90), followed by large end of
pin (70) and small spacer (80).
80
60 or 70
90
100
Figure 15: Assemble Array
(See Figure 15).
(See Figure 15).
(50), washer (40), washer (50), array (10), array/
mount arm assembly, and into nut (100) (See Figure
15). Tighten screw as required using 3/16" hex key.
array (10) (See Figure 16). Ensure both the top and
the bottoms of the Centris head are engaged into the
corresponding slots in the array (10).
10
NOTE: Dual display shown; triple display similar.
Figure 16: Install Display
Centris head knob closest to the array (10). See
"ADJUSTMENT" for additional information.
Installation Instructions
20 or 30
(20 shown; 30 similar)
50
40
50
10
Centris Head