Table of Contents
Advertisement
WM210-220-230-240S/SI
4.
Loosen two bolts on either side of pitch adjustment screw.
(See Figure 16)
5.
Adjust pitch adjustment screw until mount is at desired pitch
level. Turn clockwise to raise mounting level or turn
counterclockwise to lower mounting level. (See Figure 16)
6.
Tighten two bolts on either side of pitch adjustment screw.
(See Figure 16)
5
raise
lower
or
Figure 16
7.
Tighten two bolts installed in Step 3. (See Figure 15)
Projector Installation
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the short throw projector mounts
up to (and including) the projector does not exceed 50 lbs
(22.68 kg) for the WM210S/SI or the WM220S/SI or 25 lbs
(11.34 kg) for the WM230S/SI or WM240S/SI.
NOTE:
RPM, RPA and RSA are sold separately.
(bottom view)
RPM
RSM
Figure 17
12
NOTE:
RPM Installation
1.
2.
4
6
3.
RSM (not evaluated and tested by Underwriters
Laboratories®) Installation
1.
2.
RPA
RSA
3.
Determine hole configuration to use for each specific
projector mount. (See Figure 17)
Line up mounting holes on RPM mount with corresponding
holes on projector mounting plate. (See Figure 17)
Install four 1/4-20 x 1-1/2" Phillips pan machine screws (H)
through RPM holes and into projector mounting plate. (See
Figure 18)
2
Figure 18
Install interface and projector to RPM according to RPM
installation instructions.
Line up mounting holes on RSM mount with corresponding
holes on projector mounting plate. (See Figure 17)
Install four #10-24 x 1-3/8" Phillips pan machine screws (J)
through RSM holes and into projector mounting plate. (See
Figure 19)
2
Figure 19
Install interface and projector to RSM according to RSM
installation instructions.
Installation Instructions
Mounting plate
RPM
(H) x 4
Mounting plate
RSM
(J) x 4
Advertisement
Table of Contents
