Table of Contents
Advertisement
WM210-220-230-240S/SI
I
WS2XXS
INTERACTIVE MODEL ONLY
The Chief Interactive Mount (WM2XXSI) works with standard
projectors and Windows® and Macintosh® computers. The
Interactive Mount will transform existing whiteboards or other
hard, flat surfaces, into interactive whiteboards and allows
users to present, annotate, and interact with their projected
content and all of their desktop applications.
IMPORTANT ! : After adding batteries to the stylus (AE),
tighten the cap only to the point of being fingertip-tight.
Overtightening cap may cause the stylus to stop
transmitting signals.
Minimum System Requirements
•
Windows® System
•
Compatible PC with Pentium™ II 400 MHz+
processor and 256 MB RAM
•
Windows 2000, XP, Server 2003, Vista, or 7
•
30 MB available hard drive space
•
Available USB port
•
Macintosh® System
•
Power PC®/Intel™ 1.42 GHz+ processor and 1G
RAM
•
Mac OS X 10.5 through 10.6
•
25 MB available hard drive space
•
Available USB port
Active Capture Area Size
•
The maximum active capture area supported is:
4 ft x 7 ft or up to 94 inches diagonal measure.
•
The minimum active capture area supported is:
1.7 ft x 1.1 ft.
Motion sensor OK
7
Connection Requirement
•
The interactive mount includes a USB cable.
Screen Recording Requirements
(Currently available only on Windows platform.)
•
Pentium™ IV processor
•
1.4GHz, with 512MB RAM
Environmental Interference Guide
Ultrasound Reflections
General proximity guideline: A distance of 12 feet
(approximately 4 meters) between the motion sensor and the
eBeam receiver will normally allow good performance with the
maximum board size. (See Figure 2)
Interference can be reduced by reducing the size of the
projection area.
Motion Sensor Free Zone
Drawing surface
Figure 2
Installation Instructions
Motion sensor
12 feet
Advertisement
Table of Contents
