Fujitsu iScanner fi-6010N Operator's Manual page 131

4. Select whether or not to enable SSL (Transport Layer Security).
Select the [On] button enables SSL. If SSL is enabled, press the [Regenerate] button to cre-
ate another SSL Certificate. When a new SSL Certificate is created, the contents of the cer-
tificate are changed. The contents of the SSL Certificate are as follows.
Issued by
Shows the SSL Certificate issuer.
Valid from
Shows the SSL Certificate expiration date. The expiration date is five years from the
date on which the certificate was created. This is shown in date form.
Selecting the [Off] button disables SSL.
5. Press the [OK] button.
The communication settings are set.
ATTENTION
4.7 Using the Network Settings Menus
If the Admin Network settings are changed using the Admin Tool, the
Admin Tool is disconnected from the scanner.
If any further actions are required, the Admin Tool will need to be
reconnected to the scanner.
If SSL is enabled, SSL is also used for communication between the
Central Admin Server and the scanner. When Central Admin is
enabled, change the settings on the Central Admin Console "Central
Admin Server Settings" screen.
The following settings combinations are not possible.
Port Number "80" and SSL "On"
Port Number "443" and SSL "Off"
fi-6010N Network Scanner Operator's Guide
4
93