ZyXEL Communications P-660HNU-F1 User Manual page 92

Chapter 5 Broadband
Table 11 Broadband Add/Edit: Routing- PPPoE (continued)
Label
PPP User Name
PPP Password
PPPoE Service Name
Authentication
Method
Use Static IP Address A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not
IP Address
Dial on Demand
Inactivity Timeout
MTU
Routing Feature
NAT Enable
IGMP Proxy Enable
Apply as Default
Gateway
DNS Server - This section is not available when you select Bridge in the WAN Service Type field.
Obtain DNS info
Automatically
Use the following
Static DNS IP
Address
Primary DNS
Server
Secondary DNS
Server
92
DESCRIPTION
Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components
exactly as given.
Enter the password associated with the user name above.
Type the name of your PPPoE service here.
The ZyXEL Device supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP;
however, PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing calls.
Options are:
AUTO: Your ZyXEL Device accepts either CHAP or PAP when requested by this remote
node.
PAP: Your ZyXEL Device accepts PAP only.
CHAP: Your ZyXEL Device accepts CHAP only.
MSCHAP: Your ZyXEL Device accepts MSCHAP only. MS-CHAP is the Microsoft version
of the CHAP.
fixed; the ISP assigns you a different one each time you connect to the Internet.
Select this if you do not have a dynamic IP address.
Enter the static IP address provided by your ISP. You will only see this field if you
select Use Static IP Address.
Select Dial on Demand when you don't want the connection up all the time and
specify an idle time-out in the Inactivity Timeout field.
Specify an idle time-out in the Inactivity Timeout field when you select Dial on
Demand.
The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed
on an interface or connection. Enter the MTU in this field.
For PPPoE, the MTU value is 1492.
Select this option to activate NAT on this connection.
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish
membership in a Multicast group - it is not used to carry user data.
Select this option to have the ZyXEL Device act as an IGMP proxy on this connection.
This allows the ZyXEL Device to get subscribing information and maintain a joined
member list for each multicast group. It can reduce multicast traffic significantly.
Select this option to have the ZyXEL Device use the WAN interface of this connection
as the system default gateway.
Select this to have the ZyXEL Device get the DNS server addresses from the ISP
automatically.
Select this to have the ZyXEL Device use the DNS server addresses you configure
manually.
Enter the first DNS server address assigned by the ISP.
Enter the second DNS server address assigned by the ISP.
ADSL Series User's Guide