Setting Up Nat Port Forwarding To Allow Access To Network Servers From The Internet - ZyXEL Communications P-660HNU-F1 User Manual

Note: You must repeat this procedure for every device you want to add to your network
using WPS.
3.4 Setting Up NAT Port Forwarding to Allow Access to
Network Servers from the Internet
In this tutorial, you manage the Doom server on a computer behind the ADSL Device. In order for
players on the Internet (like A in the figure below) to communicate with the Doom server, you need
to configure the port settings and IP address on the ADSL Device. Traffic should be forwarded to the
port 666 of the Doom server computer which has an IP address of 192.168.1.34.
Tutorial: NAT Port Forwarding Setup
D=192.168.1.34
You may set up the port settings by configuring the port settings for the Doom server computer
(see Chapter 11 on page 176
Click Network Setting > NAT > Port Forwarding. Click Add new rule.
1
Enter the following values and then click Apply.
2
Service Name
WAN Interface
Start/End Ports
Translation Start/End Ports 666
Server IP Address
Protocol
ADSL Series User's Guide
LAN
port 666
for more information).
Select User Defined.
Select the WAN interface through which the Doom service is forwarded. This is
the default interface for this example, which is MyDSLConnection.
666
Enter the IP address of the Doom server. This is 192.168.1.34 for this example.
Select TCP/UDP. This should be the protocol supported by the Doom server.
Chapter 3 Tutorials
WAN
A
49