ZyXEL Communications P-660HNU-F1 User Manual page 135

Figure 45 Network Setting > Home Networking > LAN Setup
The following table describes the fields on this screen.
Table 27 Network Setting > Home Networking > LAN Setup
LABEL
LAN IP Setup
IP Address
IP Subnet Mask
DHCP Server State
DHCP
IP Addressing Values
IP Pool Starting
Address
Pool Size
DNS Values
ADSL Series User's Guide
DESCRIPTION
Enter the LAN IP address you want to assign to your ZyXEL Device in dotted decimal
notation, for example, 192.168.1.1 (factory default).
Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your ZyXEL Device automatically computes the
subnet mask based on the IP address you enter, so do not change this field unless you
are instructed to do so.
Select Enable to have your ZyXEL Device assign IP addresses, an IP default gateway
and DNS servers to LAN computers and other devices that are DHCP clients.
If you select Disable, you need to manually configure the IP addresses of the
computers and other devices on your LAN.
When DHCP is used, the following fields need to be set.
This field specifies the first of the contiguous addresses in the IP address pool.
This field specifies the size, or count of the IP address pool.
Chapter 7 Home Networking
135