Connecting The Soundpoint Ip Backlit Expansion Module - Polycom SoundPoint IP 650 User Manual

Connecting the SoundPoint IP Backlit Expansion Module

This section describes how to attach the SoundPoint IP Backlit Expansion
Module to your SoundPoint IP 650 phone. You can attach up to three
SoundPoint IP Backlit Expansion Modules.
To connect a SoundPoint IP Backlit Expansion Module to your phone:
1. Remove the rubber plug from the SoundPoint IP 650 or the SoundPoint
IP Backlit Expansion Module.
ABC DEF
1 2 3
GHI JKL MNO
4 5 6
2. Align the SoundPoint IP Backlit Expansion Module at the top of the
groove lines on the SoundPoint IP 650 phone and slide it downwards
until it clicks into position.
s
ns
ABC DEF
1 2 3
e
GHI JKL MNO
4 5 6
3. Connect the base stand by aligning the two protrusions on the stand to
the holes on the back of the Backlit Expansion Module and snap it into
place.
For each SoundPoint IP Backlit Expansion Module that you want to add,
repeat steps 1 to 3.
Using the SoundPoint IP Backlit Expansion Module
Menu
Messages
Do Not Disturb
Menu
Messages
Do Not Disturb
5 - 3