Rear Panel; Installing The Hardware - Polycom SoundStructure C16 Hardware Installation Manual

Rear Panel

1 2

Installing The Hardware

The rear-panel of the Polycom SoundStructure C16 is shown in the following
figure.
LAN C-LINK2 OBAM IR
IN OUT 12V
5 7
3 4 6 8
1
AC power connection
2
Expansion slot for SoundStructure
plug-in cards
3 Ethernet interface
4 Conference Link2 (CLink2)
interface
5
OBAM input status LED
6
OBAM input and output ports
7
OBAM output status LED
To install a SoundStructure device, follow these steps:
• Install optional plug-in card. (See page 2-4.)
• Mount the SoundStructure device onto an equipment rack or other
location. (See page 2-6.)
• Connect to LAN for control management. (See page 2-7.)
• Use Conference Link2 to connect to Polycom HDX system. (See page 2-7.)
• Use OBAM to connect multiple SoundStructure devices. (See page 2-10.)
• Connect IR port to optional receiver and/or RS-232 to control system. (See
page 2-13.)
• Connect other devices/equipment using analog input/output. (See page
2-15.)
• Connect optional logic devices. (See page 2-16.)
Installing The SoundStructure C16, C12, C8, And SR12
PIN 2: TXD
1
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
REMOTE CONTROL 1
RS-232
1
REMOTE CONTROL 2
9 10 11 12
8
9
10
11
12
13
2 3 4 5 6 7 8 9 10 11
2 3 4 5 6 7 8 9 10 11
13
IR receiver interface
RS-232 interface
Logic input and output connector
Logic input and output connector 2
Balanced audio input connectors
Balanced audio output connectors
12 13 14 15 16
12 13 14 15 16
SoundStructure C16 TM
2 - 3