Networkport Settings - Cisco TelePresence System Codec C90: Profile 65” Administrator's Manual

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents

NetworkPort settings

NetworkPort [2] Mode
Define if the network port 2 shall be enabled for direct pairing with a Cisco TelePresence Touch
screen control panel.
NOTE: Restart the system for any change to this setting to take effect.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence
Touch screen control panel connected to the port. This will enable for direct pairing between
the Touch screen control panel and the codec.
NetworkPort 2 Mode: Inactive
Example:
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
83 www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Setting passwords Appendices