Cisco TelePresence System Codec C90: Profile 65” Administrator's Manual page 112

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents
Video SelfviewDefault PIPPosition
Determine the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video SelfviewDefault Mode
setting) and fullscreen view is switched off (see the Video SelfviewDefault FullscreenMode
setting).
Requires user role: ADMIN
Value space: <Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/LowerLeft/
LowerRight >
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Video SelfviewDefault PIPPosition: Current
Example:
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Video SelfviewDefault OnMonitorRole
Determine which monitor/output to display the main video source (self-view) on after a call.
The value reflects the monitor roles set for the different outputs in the Video Output HDMI/DVI/
Composite MonitorRole settings.
The setting applies both when self-view is displayed in full screen, and when it is displayed as
picture-in-picture (PiP), but only if the Video Monitors setting is set to Dual or Quadruple.
Requires user role: ADMIN
Value space: <First/Second/Third/Fourth/Current>
First: The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to First.
Second: The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Second.
Third: The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Third.
Fourth: The self-view picture will be shown on outputs with the Video Output HDMI/DVI/
Composite MonitorRole set to Fourth.
Current: When leaving the call, the self-view picture will be kept on the same output as
during the call.
Video SelfviewDefault OnMonitorRole: Current
Example:
Video Monitors
Set the monitor layout mode.
Requires user role: ADMIN
Value space: <Single/Dual/DualPresentationOnly/Quadruple>
Single: The same layout is shown on all monitors.
Dual: The layout is distributed on two monitors.
DualPresentationOnly: All participants in the call will be shown on the first monitor, while the
presentation (if any) will be shown on the second monitor.
Quadruple: The layout is distributed on four monitors, so that each remote participant and
the presentation will be shown on separate monitors.
Video Monitors: Single
Example:
112 www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Setting passwords Appendices