Cisco TelePresence System Codec C90: Profile 65” Administrator's Manual page 69

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents
Conference [1..1] Multipoint Mode
Define how the video system handles multiparty video conferences.
If registered to a Cisco TelePresence Video Communication Server (VCS), the video system
can either use its own built-in MultiSite feature, or it can rely on the MultiWay network solution.
MultiWay requires that the video network includes a multipoint control unit (MCU).
If registered to a Cisco Unified Communications Manager (CUCM) version 8.6.2 or newer, the
video system can use either the CUCM conference bridge, or the video system's own built-in
MultiSite feature. Which one to use is set-up by CUCM.
Both Multiway and the CUCM conference bridge allows you to set up conferences with many
participants. The built-in MultiSite allows up to four participants (yourself included) plus one
additional audio call.
Note that the built-in MultiSite is optional and may not be available on all video systems.
Requires user role: ADMIN
Value space: <Auto/Off/MultiSite/MultiWay/CUCMMediaResourceGroupList>
Auto: The multipoint method available will be choosen automatically; if none are available the
Multipoint Mode will automatically be set to Off. If both MultiWay and MultiSite are available,
the MultiWay service takes priority over the built-in MultiSite.
Off: Multiparty conferences are not allowed.
MultiSite: Multiparty conferences are set up using the built-in MultiSite feature. If MultiSite is
chosen when the MultiSite feature is not available, the Multipoint Mode will automatically be
set to Off.
MultiWay: Multiparty conferences are set up using the MultiWay service. If MultiWay is
chosen when the MultiWay service is not available, the Multipoint Mode will automatically be
set to Off. This may occur when the NetworkServices MultiWay Address setting is empty or
not properly set.
CUCMMediaResourceGroupList: Multiparty conferences (ad hoc conferences) are hosted by
the CUCM configured conference bridge. This setting is provisioned by CUCM in a CUCM
environment and should never be set manually by the user.
Conference 1 Multipoint Mode: Auto
Example:
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Conference [1..1] IncomingMultisiteCall Mode
Select whether or not to allow incoming calls when already in a call/conference.
Requires user role: ADMIN
Value space: <Allow/Deny>
Allow: You will be notified when someone calls you while you are already in a call. You can
accept the incoming call or not. The ongoing call may be put on hold while answering the
incoming call; or you may merge the calls (requires MultiSite or MultiWay support).
Deny: An incoming call will be rejected if you are already in a call. You will not be notified
about the incoming call. However, the call will appear as a missed call in the call history list.
Conference 1 IncomingMultisiteCall Mode: Allow
Example:
69 www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Setting passwords Appendices