The Networkport Settings - Cisco Codec C60 Administrator's Manual

Cisco TelePresence System Codec C60/C40 and Profiles using C60/C40
Contents Introduction

The NetworkPort settings

NetworkPort [2] Mode
Define if the network port 2 shall be enabled for direct pairing with the Cisco TelePresence Touch
for C Series.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence
Touch unit connected to the port. This will enable for direct pairing between the touch unit and
the codec.
Example: NetworkPort 2 Mode: Inactive
D14636.06 Profile C60-C40 and Codec C60-C40 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings
The NetworkServices settings
NetworkServices Multiway Address
The Multiway address must be equal to the Conference Factory Alias, as configured on the Video
Communication Server. The Multiway™ conferencing enables video endpoint users to introduce a
3rd party into an existing call.
Multiway™ can be used in the following situations:
1) When you want to add someone else in to your existing call.
2) When you are called by a 3rd party while already in a call and you want to include that person
in the call.
Requirements: The Codec C20 must be running TC3.0 (or later), Codec C90/C60/C40
must be running TC4.0 (or later), EX90/EX60/MX200 must be running TC4.2 (or later), Video
Communication Server (VCS) version X5 (or later) and Codian MCU version 3.1 (or later).
Endpoints invited to join the Multiway™ conference must support the H.323 routeToMC facility
message if in an H.323 call, or SIP REFER message if in a SIP call.
Requires user role: ADMIN
Value space: <S: 0, 255>
Example: NetworkServices Multiway Address: "h323:multiway@company.com"
NetworkServices Multiway Protocol
Determine the protocol to be used for Multiway calls. NOTE: Requires a restart of the codec.
Requires user role: ADMIN
Value space: <Auto/H323/Sip>
Example: NetworkServices Multiway Protocol: Auto
NetworkServices H323 Mode
Determine whether the system should be able to place and receive H.323 calls or not. NOTE:
Requires a restart of the codec.
Requires user role: ADMIN
Value space: <On/Off>
Example: NetworkServices H323 Mode: On
53
Password protection
Format: String with a maximum of 255 characters.
Auto: The system will select the protocol for Multiway calls.
H323: The H323 protocol will be used for Multiway calls.
Sip: The SIP protocol will be used for Multiway calls.
On: Enable the possibility to place and receive H.323 calls (default).
Off: Disable the possibility to place and receive H.323 calls.
Administrator guide
Appendices Contact us
www.cisco.com