Cisco TelePresence System Codec C90: Profile 65” Administrator's Manual page 60

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents
Audio Output Line [1..6] Equalizer ID
Select the audio output line equalizer ID.
Requires user role: ADMIN
Value space: <1..8>
Range: Select EqualizerID 1 to 8.
Audio Output Line 1 Equalizer ID: 1
Example:
Audio Output Line [1..6] Equalizer Mode
Set the audio output line equalizer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: No equalizer.
On: Enable the equalizer for the audio output line.
Audio Output Line 1 Equalizer Mode: Off
Example:
Audio Output Line [1..6] Level
Define the output level of the Audio Output Line connector, in steps of 1 dB.
See the Audio Level tables in the Physical Interfaces Guide for the codec for a complete
overview of the menu values represented in dB.
Requires user role: ADMIN
Value space: <-24..0>
Range: Select a value from -24 to 0 dB.
Audio Output Line 1 Level: -10
Example:
Audio Output Line [1..6] Mode
Set the audio output line mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the Audio Line output.
On: Enable the Audio Line output.
Audio Output Line 1 Mode: On
Example:
D14635.13 Profile C90 and Codec C90 Administrator Guide TC7.0, DECEMBER 2013.
Introduction Web interface System settings System settings
Audio Output Line [1,3] Type
Determine if the Audio Line output will be analog or digital type output. The digital output on the
Cisco TelePresence Profile systems are identified as DNAM (Digital Natural Audio Module).
Requires user role: ADMIN
Value space: <Auto/SPDIF>
Auto: If a Digital NAM is detected then SPDIF mode will be selected, otherwise analog mode
will be selected.
SPDIF: Set to SPDIF when you want the line output to be in digital mode.
Audio Output Line 1 Type: Auto
Example:
Audio Output Line [2,4,5,6] Type
Line output 2, 4, 5, 6 are dedicated analog outputs, hence type can be set to analog only.
Requires user role: ADMIN
Value space: <Analog>
Analog: Can be set to analog only.
Audio Output Line 2 Type: Analog
Example:
Audio Microphones Mute Enabled
Determine whether audio-mute is allowed or not. The default value is True.
Requires user role: ADMIN
Value space: <True/InCallOnly>
True: Muting of audio is always available.
InCallOnly: Muting of audio is only available when the device is in a call. When Idle it is not
possible to mute the microphone. This is useful when an external telephone service/audio
system is connected via the codec and is to be available when the codec is not in a call.
When set to InCallOnly this will prevent the audio-system from being muted by mistake.
Audio Microphones Mute Enabled: True
Example:
60 www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
Administrator Guide
Setting passwords Appendices