Cisco Codec C Series Getting Started Manual page 10

Cisco TelePresence Video Systems
Contents
Configuration tasks (continued)
Setting the H.323 and SIP parameters
(when not set by a provisioning system)
To get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SIP protocol for video calls.
Choose one of the following methods to set the H.323 and
SIP parameters:
Touch controller
Remote control
and on screen menu
Web interface
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction User interfaces
Setting date and time
(when not set by a provisioning system)
When setting up your video conference system, you should
check that the date and time settings are correct. Among
other things this information is used to time stamp messages
transmitted to gatekeepers and other network elements.
Choose one of the following methods to set the date and time:
Read more...
Touch controller
Remote control
Read more...
and on screen menu
Read more...
Web interface
Confirguration Configuration
Setting the menu password
We strongly recommend that you set a password for the
Administrator Settings menu.
This menu, which is available on both the Touch controller and
the remote control, gives access to settings that affect the
behavior of the video conference system.
Choose one of the following methods to set-up the menu
password:
Read more...
Read more...
Read more...
10
Getting Started Guide
Appendices
Remote control
and on screen menu
Web interface
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Contacts
Read more...
Read more...