Configuration Using The Remote Control And On-Screen Menu - Cisco Codec C Series Getting Started Manual

Software version tc7.0
Hide thumbs Also See for Codec C Series:
Table of Contents

Advertisement

Cisco TelePresence Video Systems
Contents

Configuration using the remote control and on-screen menu*

Waking up the system
If there is no menu on screen, press
Home
control to show the menu.
If the system does not show a menu on screen:
• Make sure the monitor is connected and has been switched
on.
• Make sure the remote control has batteries installed.
• Make sure the system is switched on.
If the system has just been switched on, wait a few minutes to
allow the system to start up.
If there is still no menu on screen, make sure the monitor cable
is connected to the basic video output connector. If in doubt,
see the installation guide for your product.
* This section does not apply for EX Series and MX Series.
Back to task overview
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction
User interfaces
(
) on the remote
Confirguration
Configuration
Remote control and
on-screen menu
17
Getting Started Guide
Appendices
Contacts
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents