The Settings Menu On The Touch Controller - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents
The Settings menu on the Touch
controller
All settings are not available on all products; therefore the menu
items shown to the right may or may not be present on your
system.
You can find a complete description of the Touch controller
menus in the user guide for your video conference system.
The Administrator Settings menu is protected with the system
password.
If needed, you can set an added restriction to users' access
to the settings. This can be done on the web interface. Go
to Configuration > System Configuration > User Interface
set User Preferences to Off. With this restriction, only
Information, Call Status, Diagnostics and
for the users.
To open the Settings menu, tap the system or user name in the
upper left corner and tap Settings.
D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.
Introduction User interfaces
Settings
Background
Ringtone & Sound
Bluetooth Headset
Camera Control
Display
Main Source Selection
Language
Date, Time & Location
System Information
and
Call Status
System
Diagnostics
Restart are available
Restart
Administrator
Configuration
The Settings menu
• Background: Select a background picture for your Touch controller and main video
display.
• Ringtone & Sound: Select a ring tone, the ring tone volume and key tone.
• Bluetooth Headset: Select a bluetooth headset.
• Camera Control: Set the camera parameters.
• Display: Select brightness, color temperature and DVI mode for the main video display.
• Main Source Selection: Select the main input source, e.g. camera control.
• Language: Select the language for the user interface.
• Date, Time & Location: Configure date and time settings.
• System Information: See an overview of the system configurations.
• Call Status: See an overview of the call parameters when in call, e.g. protocols,
transmit and receive rates, packet loss.
• Diagnostics: Set additional system logging on.
• Restart: Select this option to restart the system.
• Administrator: See below.
The Administrator Settings menu
Back
| Administrator Sett
• Call
Call Details
• Provisioning: Start the provisioning wizard.
Provisioning
• Multiway: Insert the address of the Multiway server.
Multipoint Mode
• IP &
IP & VLAN
connected via LAN there are separate entries for the codec and the Touch.
SIP • SIP: Configure the SIP settings.
• H323: Configure the H.323 settings.
H323
EMC Resilience • Web
• EMC
Web Snapshots
ience to electromagnetic noise present.
Reset
• Reset: Select this option for a complete factory reset. All your settings
are reset.
31
Appendices Appendices
Details: Configure the default bit rate and auto answer settings.
VLAN: Configure the IP and VLAN settings. If the Touch controller is
Snapshots: Allow/Disallow the web snapshot feature.
Resilience: Select this option to change the Touch controller's resil-
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts