Hardware Features - Allied Telesis AT-3726XL Installation Manual

Product Description

Hardware Features

1-4
The switches have the following major hardware features:
# 24 or 16 10Base-T ports for the AT-3726XL/AT-3716XL, plus
one built-in 10/100Base-TX port capable of full- or half-duplex
configurable through auto-negotiation (IEEE 802.3u standard)
or manually settleable.
# 12 10Base-FL ports (SC/ST) for the AT-3714FXL, capable of full-
or half-duplex, manually configurable.
# Additional 100Base modular port provides the option of a
100Base-TX or 100Base-FX port using one of the MDAs.
# Non-blocking, clear-channel architecture delivers wire-speed
bridging and delivers up to 880 Mbps aggregate bandwidth
for AT-3726XL, up to 720 Mbps for the AT-3716XL, and up to
640 Mbps for the AT-3714FXL to workstations, servers, routers
and between switches.
# Shared-memory architecture of up to 4 MB of packet buffer
using cost-effective EDO DRAM (dependent on model
number) which virtually eliminates packet loss.
# Store-and-forward switching mode allows for full error
checking.
# Hardware-base support for static entries and self-learning of
active MAC addresses and their associated Virtual LANs
(VLANs).
# Stores 2K MAC addresses in CAM.
# Port mirroring.
# VLANs configuration provides broadcast traffic control,
firewall protection, and simplifies adds, moves, and changes.
Supports thirty-two VLANs configurable by port or by tagging.
# Supports IEEE 802.1Q VLAN tagging.
# Half-duplex back pressure.
# Embedded 25 MHz 486 CPU supports management functions.
Sufficient system memory which includes DRAMs and Flash
memory for convenient firmware upgrades.
# In-band configuration of switch through Telnet, Remote
Omega.
# In-band configuration through web, web-based Omega.
# Out-of-band configuration through RS232 connector, Local
Omega.