Bosch MIC IP PSU User Manual page 68

68 en | Configuration using a Web browser
The encoder contains an integrated video content analysis (VCA), which can detect and
analyze changes in the signal using image processing algorithms. Such changes can be due to
movements in the camera's field of view.
You can select various VCA configurations and adapt these to your application as required.
You can configure two profiles with different VCA configurations. You can save profiles on
your computer's hard drive and load saved profiles from there. This can be useful if you want
to test a number of different configurations. Save a functioning configuration and test new
settings. You can use the saved configuration to restore the original settings at any time.
1.
2.
3.
4.
You can switch off the video content analysis completely if the device's full power is to be
made available for the encoder.
VCA configuration
Select one of the profiles here to activate it or edit it. The Silent MOTION+ configuration is
active by default. In this configuration, metadata is created to facilitate searches of
recordings; however, no alarm is triggered. You can rename the profile.
1.
2.
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal management.
Preset
Options are: Off, or any of the presets that have already been saved
Alarm status
The alarm status is displayed here for information purposes. This means you can check the
effects of your settings immediately.
Aggregation time [s]
You can set an aggregation time of between 0 and 20 seconds if necessary. The aggregation
time always starts when an alarm event occurs. It extends the alarm event by the value set.
This prevents alarm events that occur in quick succession from triggering several alarms and
successive events in a rapid sequence. No further alarm is triggered during the aggregation
time.
Note that the value for the pre-alarm time must be greater than the value for the aggregation
time, so that also the alarm event is recorded. The post-alarm time set for alarm recordings
only starts once the aggregation time has expired (see Section 4.33 Recording Profiles,
page 60).
Analysis type
Select the required analysis algorithm. By default, only MOTION+ is available – this offers a
motion detector and essential recognition of tampering.
F.01U.265.804 | 1.6 | 2012.08
Select a VCA profile and enter the required settings.
If necessary, click the Default button to return all settings to their default values.
Click the Save... button to save the profile settings to a file. A new window is opened, in
which you can specify where you want to save the file and what name you want to save it
under.
Click the Load... button to load a saved profile. A new window opens in which you can
select the profile file and specify where to save the file.
To rename the file, click the icon to the right of the list field and enter the new profile
name in the field.
Click the icon again. The new profile name is saved.
User Manual
MIC Series IP Power Supply
Bosch Security Systems, Inc.