Bosch MIC IP PSU User Manual page 45

MIC Series IP Power Supply
–
–
–
–
CAUTION!
Change the profiles only once you are fully familiar with all the configuration options.
In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections. Bear this fact in mind when assigning the profile.
NOTICE!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
You can enter a new name for the profile. The name is then displayed in the Non-recording
profile list field on the Encoder Streams page in the lists of selectable profiles.
CAUTION!
Do not use any special characters, for example &, in the name.
Special characters are not supported by the system's internal management.
Target bit rate
You can limit the bit rate for the encoder to optimize utilization of the bandwidth in your
network. The target bit rate should be set according to the desired picture quality for typical
scenes with no excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can be temporarily exceeded up to the value entered in the Maximum bit rate field.
Maximum bit rate
This maximum bit rate is not exceeded under any circumstances. Depending on the video
quality settings for the I and P-frames, this fact can result in individual images being skipped.
The value entered here must be at least 10% higher than the value entered in the Target bit
rate field. If the value entered here is too low, it will automatically be adjusted.
Encoding interval
The setting selected here determines the interval at which images are encoded and
transmitted. The image rate in ips (images per second) is displayed next to the text field.
Video resolution
Here you can select the desired resolution for the video image. The following resolutions are
available:
–
–
Bosch Security Systems, Inc.
ISDN (2B)
For ISDN connections via two B-channels, resolution 352 × 288/240 pixels
ISDN (1B)
For ISDN connections via one B-channel, resolution 352 × 288/240 pixels
MODEM
For analog modem connections with 20 kbps, resolution 352 × 288/240 pixels
GSM
For GSM connections at 9,600 baud, resolution 352 × 288/240 pixels
CIF
352 × 288/240 pixels
4CIF/D1
704 × 576/480 pixels
User Manual
Configuration using a Web browser | en
F.01U.265.804 | 1.6 | 2012.08
45