Bosch MIC IP PSU User Manual page 23

MIC Series IP Power Supply
27. Test the washer by pressing the red button marked SW1 PUMP ON on the PCB.
NOTICE!
For installation of the MIC Washer Kit (MIC-WKT), MIC 8-input Alarm Card (MIC-ALM) or
Biphase converters (MIC-BP3 or MIC-BP4), please see their respective manuals.
28. Verify that the thermal pads are in the correct position on the encoder or on the built-in
Figure 3.9 Thermal pads in correct position on the encoder
Figure 3.10 Location of correct position for thermal pads on the inside of the lid of the enclosure
29. After all wiring and connections are complete, connect the power supply to the power
30. Verify that the following LEDs are lit on the PCB (depending on the model of MIC PSU):
Figure 3.11 MIC Series power supply LED position (at the "top right" of the PCB)
Bosch Security Systems, Inc.
LED 3 illuminates in response to telemetry commands from the control room to turn on
the washer. Note that the software in the camera prevents the washer from running more
than 10 seconds continuously to prevent emptying the washer bottle.
stand-offs on the inside of the lid of the enclosure. Correct positioning of the thermal
pads is imperative, or the encoder may not function. See the photos below for the
correct positioning.
source. The PSU should now have power and be operational.
Number LED Description
MIC Non-IR models
1 LED 2 18 VAC power on to camera
2 LED 4 Power on for optional heater
3 LED 3 18 VAC power on camera
4 LED 5 Power on for optional heater
User Manual
Installation | en 23
F.01U.265.804 | 1.6 | 2012.08