Chapter 13
Installing External Non-Cisco Modules
Before Installing
Read this section and the
installation procedures in this chapter.
Prepare the Installation Site
The procedures in this chapter assume that you have prepared the installation site according to the
information in the
Read the Safety Information
Before performing any of the tasks in this chapter, you must read the safety warnings in this section and
in the
Preventing Electrostatic Discharge Damage
Many of the components discussed in this chapter are sensitive to electrostatic discharge (ESD) damage,
which can occur when electronic cards or components are handled improperly, results in complete or
intermittent failures.
To prevent ESD damage, follow these guidelines:
•
•
•
•
•
Cabling Guidelines
Follow these guidelines for using cables with the router:
•
•
•
•
OL-26223-04
"Installation Safety and Site Preparation"
"Installation Safety and Site Preparation"
"Installation Safety and Site Preparation"
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
Place the removed memory card on an antistatic surface or in a static shielding bag. If the card will
be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on the body only; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
Position cables so that they do not place strain on the router connectors.
Organize cables into bundles when necessary to avoid intertwining.
Inspect cables to ensure adequate routing and bend radius.
Install cable ties that comply with your site requirements.
chapter.
chapter.
Cisco 1240 Connected Grid Router Hardware Installation Guide
Before Installing
chapter before following any
13-3