Cabling Guidelines; Related Information; Basic Hardware Installation - Cisco 1240 Hardware Installation Manual

Related Information

To prevent ESD damage, follow these guidelines:
•
•
•
•
•

Cabling Guidelines

Follow these guidelines for using cables with the router:
•
•
•
•
Related Information
This chapter describes installation procedures. For detailed, technical information about the router
hardware, including connector and cable descriptions, specifications, and pinouts, see the following
chapters:
•
•

Basic Hardware Installation

This section describes basis router installation steps. This is the minimum configuration required for the
router to power up and begin operating on the backhaul network.
The steps in this section require that AC power and Ethernet network connections are available at the
installation location, as described in the
the
The tasks in this section include:
•
•
Cisco 1240 Connected Grid Router Hardware Installation Guide
6-2
Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
Connect the equipment end of the strap to an unfinished chassis surface.
Place any removed memory card on an antistatic surface or in a static shielding bag. If the card will
be returned to the factory, immediately place it in a static shielding bag.
Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages
on the body only; ESD voltages on clothing can still cause damage.
Do not remove the wrist strap until the installation is complete.
Position cables so that they do not place strain on the router connectors.
Organize cables into bundles when necessary to avoid intertwining.
Inspect cables to ensure adequate routing and bend radius.
Install cable ties that comply with your site requirements.
The "Router Hardware Description"
internal and external features and connectors.
The "Connector and Cable Specifications"
cables.
"Preparing for Network Connections" section on page
Connect to the Ethernet Backhaul Network, page 6-3
Connecting to AC Power, page 6-4
chapter describes all aspects of the router hardware, including
appendix lists pinouts for the router connectors and
"Power Guidelines and Requirements" section on page 2-5
2-5.
Chapter 6 Installing the Router
and
OL-26223-04