Mounting Instructions - Cisco 1240 Hardware Installation Manual

Mounting Instructions

The instructions for the procedures in this section refer to the mounting plate features shown in
Figure
Figure 5-11
1
2
3
4
Item
1
2
3
4
To attach the mounting bracket to the mounting plate, follow these steps and refer to
mounting plate must be installed according to the instructions in the
Pole" section on page
What You Need
Mounting bracket and hardware included in the the
•
13-mm box-end socket wrench
•
Step 1 Assemble four sets of bracket hardware (washer, split lock washer, and bolt) as shown in the
Bracket Hardware" section on page
Place the mounting bracket against the mounting plate by inserting the bracket quick hang notch over
Step 2
the mounting plate quick hang stud (
Thread the serrated nut onto the quick mount stud (
Step 3
Align the pivot grooves (
Step 4
Follow these guidelines:
Each of the four pivot grooves on the bracket must be attached to at least one bracket mount hole on
•
the mounting plate.
The final desired orientation of the mounting plate and router determine which bracket mount holes
•
are used.
Cisco 1240 Connected Grid Router Hardware Installation Guide
5-14
5-11.
Mounting Bracket Details
Description
Pivot grooves (4)
Quick hang notch
Quick hang slots (2)
Optional wall-mount holes (4)
5-8.
) on the bracket with four of the bracket mount holes (
2
"Mounting Bracket Kit" section on page 5-4
5-13.
).
4
) and hand tighten (do not overtighten).
4
Chapter 5 Mounting the Router
Figure 5-12. The
"Install the Mounting Plate onto a
"Assemble
) on the mounting plate.
1
OL-26223-04