Materials And Tools You Supply; Unmounting Instructions; Disconnect Router Ac Power - Cisco 1240 Hardware Installation Manual

Unmounting the Router
This chapter describes the safety information, equipment, and procedures required to unmount the
Cisco 1240 Connected Grid Router (CGR 1240 or router) from a vertical pole. This chapter contains the
following topics:
•
•
•

Materials and Tools You Supply

•
•

Unmounting Instructions

This section includes the procedures required to unmount the router on any supported pole type.
Power off the router by following instructions in the
Step 1
•
•
Remove/disconnect any external cables (for example, the external Ethernet connector at base of unit).
Step 2
Open the router door using the socket wrench and by following instructions in the
Step 3
section on page
Disconnect the internal cables, taking care to remove cable from cable glands.
Step 4
Close the router door by following instructions in the
Step 5
Note
OL-26223-04
Materials and Tools You Supply, page 8-1
Unmounting Instructions, page 8-1
Transporting the Router, page 8-3
1/2-inch (13-mm) socket wrench
#2 Phillips-head screwdriver
Disable AC power (See the
Disable BBUs (See the "Disable the Router BBU at the CLI" section on page 7-2
the BBU by Disconnecting the BBU Harness Cable" section on page
4-3.
Closing the door before transporting the router can prevent personal injury and damage to the
unit.
C H A P T E R
"Powering Off the Router" section on page
"Disconnect Router AC Power" section on page
"Closing the Door" section on page
Cisco 1240 Connected Grid Router Hardware Installation Guide
8
7-1:
7-2).
or the "Disable
7-3).
"Opening the Door"
4-4.
8-1