Using Cable Glands; Ordering Cisco Cable Glands; Tools You Supply - Cisco 1240 Hardware Installation Manual

Chapter 6 Installing the Router
Figure 6-7
Item
1
2

Using Cable Glands

This section describes how to use cable glands with router cables that are threaded through the chassis
cable ports that are described in the
page
Caution The cable glands must be used for all cables that are threaded through the router chassis cable ports to
prevent exposing the router interior to environmental elements.

Ordering Cisco Cable Glands

You can order a cable gland kit from Cisco using the model number CGR-IP67GLAND. Each kit
contains one cable gland. See the
this part.

Tools You Supply

You must supply:
•
•
OL-26223-04
Chassis Cable Ports—For Cabling to External Connectors or Devices
1 1
Description
These two ports on the router base are reserved for SPF module cables. One of these ports is
shown with the port plug that must be used when the port is not in use.
These two ports on the router door are reserved for non-Cisco module cables.
6-12.
13-mm box-end wrench or socket set to remove port seals from the router
15/16-inch (24 mm) open-end wrench
2
"External Connections and Chassis Cable Ports" section on
"Router Hardware Description"
Cisco 1240 Connected Grid Router Hardware Installation Guide
Additional Router Connections
chapter for detailed information about
6-13