Connect To The Ethernet Backhaul Network - Cisco 1240 Hardware Installation Manual

Chapter 6 Installing the Router

Connect to the Ethernet Backhaul Network

The available Ethernet connection must meet the requirements described in the
Site Preparation"
Note The external connector described in this section is connected to one of the Ethernet ports inside the
router chassis. The internal port used depends on the router hardware configuration. If you are
connecting the external Ethernet connector to an internal Ethernet port for the first time, Cisco
recommends you connect it to the ETH 2/5 port.
Remove the cover from the external Ethernet connector.
Step 1
Connect the local Ethernet cable to the router exterior Ethernet connector on the base of the router
Step 2
(Figure
Tighten the cable coupling ring (shown in
Step 3
ensure an adequate seal over the connector.
Figure 6-1
Item
1
OL-26223-04
chapter.
6-1).
External Ethernet Connector
Description
External Ethernet connector
Figure 6-2) over the exterior router Ethernet connector to
1
Cisco 1240 Connected Grid Router Hardware Installation Guide
Basic Hardware Installation
"Installation Safety and
6-3