Preparing For Installation; Chapter 2 Switch Installation - Cisco Catalyst 3850 Hardware Installation Manual

Preparing for Installation

Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury
Warning
and equipment damage. Statement 48
Ethernet cables must be shielded when used in a central office environment. Statement 171
Warning
Warning Voice over IP (VoIP) service and the emergency calling service do not function if power fails or is
disrupted. After power is restored, you might have to reset or reconfigure equipment to regain access
to VoIP and the emergency calling service. In the USA, this emergency number is 911. You need to be
aware of the emergency number in your country. Statement 361
Warning If a Cisco external power system is not connected to the switch, install the provided connector cover
on the back of the switch. Statement 386
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Read the installation instructions before connecting the system to the power source. Statement 1004
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
The plug-socket combination must be accessible at all times, because it serves as the main
Warning
disconnecting device. Statement 1019
Warning Use copper conductors only. Statement 1025
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Catalyst 3850 Switch Hardware Installation Guide
2-2
Chapter 2 Switch Installation
OL-26779-02