Configuring a Network Module
C3850-NM-2-10G module
The first two parts are natively 1G ports and the last two ports are natively 10G ports. So you configure
the 1G posts as GigabitEthernet1/1/1 through GigabitEthernet1/1/2, and configure the last two ports as
TenGigabitEthernet1/1/3 through TenGigabitEthernet1/1/4, even when you are operating the last two
ports as 1G. There are only four interfaces which are valid and the other four should not be used even
though they still show up in the CLI.
Interface
GigabitEthernet1/1/1
GigabitEthernet1/1/2
GigabitEthernet1/1/3
GigabitEthernet1/1/4
TenGigabitEthernet1/1/1
TenGigabitEthernet1/1/2
TenGigabitEthernet1/1/3
TenGigabitEthernet1/1/4
Supported GBICs
TenGigabitEthernet:
•
•
•
•
•
•
•
Catalyst 3850 Switch Hardware Installation Guide
3-8
SFP-H10GB-CU1M
SFP-H10GB-CU3M
SFP-H10GB-CU5M
SFP-10G-SR
SFP-10G-LRM
SFP-10G-LR
SFP-10G-ER
Action
Configure this interface
Configure this interface
Disregard
Disregard
Disregard
Disregard
Configure this interface, even when operating as 1G
Configure this interface, even when operating as 1G
GigabitEthenet
GLC-T (10/100/1000)
•
GLC-SX-MM
•
GLC-LH-SM
•
•
GLC-SX-MMD
•
GLC-LH-SMD
GLC-ZX-SM
•
GLC-ZX-SMD
•
GLC-BX-D
•
GLC-BX-U
•
CWDM SFP
•
SFP-GE-S
•
SFP-GE-L
•
SFP-GE-Z
•
DWDM SFP
•
DWDM SFP (add.)
•
Chapter 3
Installing a Network Module
OL-26779-02