Cable And Adapter Specifications; Stackwise Cables; Sfp And Sfp+ Module Cable Specifications - Cisco Catalyst 3850 Hardware Installation Manual

Appendix B Connector and Cable Specifications
The RJ-45 console port uses an 8-pin RJ-45 connector (See
RJ-45-to-DB-9 adapter cable is used to connect the console port of the switch to a console PC. You need
to provide a RJ-45-to-DB-25 female DTE adapter if you want to connect the switch console port to a
terminal. You can order a kit (part number ACS-DSBUASYN=) containing that adapter. For console
port and adapter pinout information, see

Cable and Adapter Specifications

•
•
•
•
•
•

StackWise Cables

You can order these Catalyst 3850 to Catalyst 3850 StackWise cables (nonhalogen) from your Cisco
sales representative:
•
•
•

SFP and SFP+ Module Cable Specifications

For cabling specifications, refer to the
Each port must match the wave-length specifications on each end of the cable, and the cable must not
exceed the stipulated cable length. Copper 1000BASE-T SFP module transceivers use standard four
twisted-pair, Category 5 cable at lengths up to 328 feet (100 meters).
OL-26779-02
StackWise Cables, page B-5
SFP and SFP+ Module Cable Specifications, page B-5
Four Twisted-Pair Cable Pinouts, page B-6
Two Twisted-Pair Cable Pinouts, page B-6
Identifying a Crossover Cable, page B-7
Console Port Adapter Pinouts, page B-7
STACK-T1-50CM= (0.5-meter cable)
STACK-T1-1M= (1-meter cable)
STACK-T1-3M= (3-meter cable)
Table B-1
Table B-1 and Table B-2.
Cisco SFP and SFP+ Transceiver Module Installation Notes.
Catalyst 3850 Switch Hardware Installation Guide
Cable and Adapter Specifications
and Table B-2.) The supplied
B-5